Milweld H-10 Spezifikationen PDF herunterladen (Seite 15)

OM-154 501 Page 11

3-8. Installing Wire Spool And Adjusting Hub Tension

1 Wire Spool

2 Gun Contact Tip

If necessary, cut welding wire off at

contact tip, and retract wire onto

spool and secure.

3 Retaining Ring

4 Compression Spring

Remove ring and pull off spool.

Compression spring is used with 8

in (200 mm) spools.

5 Hub

6 Hub Pin

Slide spool onto hub so wire feeds

off bottom. Turn spool until hub pin

fits hole in back of spool. Reinstall

retaining ring.

7 Hub Tension Nut

Grasp spool in one hand and turn

while using a wrench to adjust hub

tension nut. When a slight force is

needed to turn spool, tension is set.

Thread welding wire (see Section

3-9). Close door.

Tools Needed:

15/16 in

Ref. ST-801 103-B / Ref. ST-072 573-B

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Keine Kommentare

Milweld H-10 Spezifikationen Seite 15